Bench / BSL / Boot Tool
BDM Pro is a background-debug-mode bench programmer in the same family as the BDM100, used to read and write Motorola/Freescale-based ECUs through their internal BDM port on the bench. Combined with a BDM frame and probe adapters, it dumps and writes flash and EEPROM on many Bosch EDC16 and comparable ECUs, mainly for full backups, writing modified maps and recovering units that cannot be reached over OBD. It is a low-cost tool typical of the earlier chip-tuning era and is limited to the BDM-accessible ECU generation, without support for the later Tricore/BSL controllers. Coverage and reliability vary between the many clone versions on the market.
BDM Pro pulls the raw dump off older ECUs; Softechpro Solutions applies EGR/DTC-off modules and fixes the checksum on that dump before the write. Complementary roles.
See Softechpro plansTry the file service