Bench / BSL / Boot Tool
The BDM100 is a background-debug-mode (BDM) ECU programmer used to read and write Motorola/Freescale-based control units directly on the bench through their internal debug port, bypassing the OBD connection. Paired with a BDM frame and the right probe adapters, it accesses the flash and EEPROM of many Bosch EDC16/ME9-era ECUs to pull complete firmware and write it back. Tuners use it where OBD flashing is unavailable or where a full memory dump is needed, and to recover ECUs. Sold widely as inexpensive clone hardware, it is a classic entry-level bench tool. It does not support the newer Tricore/BSL-based ECUs that replaced the BDM-accessible generation.
A BDM100 gets the raw dump off older ECUs; Softechpro Solutions then applies EGR/DTC-off modules and corrects the checksum on that dump before you write it back. Different steps of one workflow.
See Softechpro plansTry the file service